Effective Configuration – it is the current running configuration or configuration in production.ģ.Run the alicreate command to create aliases for the HBA addresses that you identified by either running switchshow command or manually.Any previously created zoning configurations that available are also displayed. Defined Configuration – It is the section in which zones and aliases are listed.This will display two sections, Defined Configuration and Effective Configuration. Note:Any devices that connect using NPIV use nsshow command to find the WWPN addresses logged in to the port.If you cannot find the WWPN listing, you have to identify the WWPN manually from server / HBA and run “ nodefind WWPN “ to verify that the WWPN is available on switch for zoning.Ĭfgshow will display the configuration and how the zoning is currently configured. Here I describes the procedure that should be followed to configure zoning on a Brocade switch using the CLI.Follow the below procedure to create zone from CLI 1.Run the switchshow command.This will help you to identify the HBA address of both the target and initiator ports which will be required for configuration. When we ran latest version java we will face difficult with GUI mode so we have to go with CLI. A World Wide Name, or WWN, is a 64-bit address used in fibre channel networks to uniquely identify each element in a Fibre Channel network.Normally everyone uses GUI for creating zone because looks very easy on GUI, but there is dependency JAVA with specific version.
And zoning manages communication of hosts and storage nodes, zone contains WWN name of these devices. SAN zoning is a method of creating logical groups over the physical configuration of the fabric and allowing communication / access of Fibre Channel devices by grouping them.
0 kommentar(er)
